Tanis Map Room
Posted on February 21, 2024
Difficulty: 
InPrintConditon was a Patreon subscription that developed some amazing 3D playsets and accessories for printing. Sadly, they recently shuttered their doors, and the world is lesser for it.
This is their Map Room playset. I printed using Siraya Fast Tech Grey in an Elegoo Jupiter. Most of the pieces are hollow. Fun Fact: If left in the sun to cure (because the curing box at the time was too small), don’t leave in the sun for too long. Being hollow, that meant the sun-side cured at a different rate than the opposite side, resulting in some warping.
I used some textured “sand” spray paint to give it the proper desert look.
Created July 2023
Easy: A simple parts swap. Little if any paint.
Basic: Some modified parts. Mostly a new paint job.
Skilled: Lots of new and modified parts. “Frankensteining” often involved.
Advanced: All of the above, plus a great deal of original sculpting.
No Comments »